Question
jasper bead
I see that you use a dremel tool which I just bought. I am trying to even out holes in large beads of jasper and lapis where the hole is rough in the middle, and I am trying to make the holes accept a 1 mm cord. What dremel bit can I use? The smallest bit is too small, and the next largest is too large!
Is there a particular bit I could look into? My dremel tool is 1100-01 cordless 7.2 volt. Many thanks for any help!
AnswerHi,
Use triple ripple daimond bits, here is a link to buy them.
http://www.alpha-supply.com/diamond-tools-diamond-tools-diamond-drills-triple-ri...
You could try the 1.5 mm bit. Go slow and keep the bit cool with water.
Regards,
Steven D.Covey
