QuestionQUESTION: hi, can you send me a video on how to set the blades so that the outliner will cut as close as possible, thanks
ANSWER: Hello I don't have the right camera to show you at this time but if you like I can try to walk you through it!
---------- FOLLOW-UP ----------
QUESTION: k please walk me through it! =)
ANSWER: Ok first let me say this may take a few days but we have to do it I will tell you things to do in steps every time you get it and do what I say just say done. OK first take the blade off but PLEASE be sure to do it over a counter or table because if any part of that blade hits the floor I guaranteed you will need a new one!
---------- FOLLOW-UP ----------
QUESTION: k do i unscrew the top 2 screws to take it off or the 2 under the blade or all four? let me know this then tell me the n ext step after taking off the blade
ANSWER: You want to take off the two big screws directly on the blade again do it over a counter or table or you will loose a screw or drop your blade, second once the blade is off turn the blade around you will see two small screws on the inside of the blade unscrew them slightly (about half way)!
---------- FOLLOW-UP ----------
QUESTION: done, can you just tell me all the steps in detail, so that this can go by faster, thanks
AnswerIf that's what you want ok now that you have the screws loose turn the blade upside down being careful not to let the inner blade fall place the teeth on the table or a hand held mirror tilt the blade slightly towards you and tighten the two little screws back the key is to get the inner blade as close to the outer blade with out going over. Hope this helps!
